Sreelatha Gaddam

Sreelatha Gaddam

Quality Control Analyst III

Curiaglobal

Profile ID RP-003-1847 Joined 2025-03-12 5 articles
0Connections
8
Total Views
5
Total Publications
94
Publication Views

Articles(5)

Authors: G. Sreelatha, S. Kushwaha, V.J.Rao, and P. Padmaja

DOI: 10.1021/ie101004q

Volume17
Issue49
Pages8106-8113
Abstract

This study investigates the potential uses of palm shell, pretreated with sulfuric acid (APSP) for the adsorption of AOII, DSB, and AV7. The effects of different system variables like adsorbent dosage, pH, contact time, and temperature were studied. Optimum pH values for all the three dyes were determined as 1.0. Equilibrium was achieved within 30 min. Langmuir I, II, III, IV and Freundlich isotherm models were applied to describe the equilibrium isotherms at different temperatures, and the langmuir model was found to agree very well with the experimental data. The maximum adsorption capacity was found to be 2180.05 mg/g, 1199.99 mg/g, and 243.9 mg/g for AOII, DSB, and AV7, respectively. Thermodynamic parameters such as change in free energy (ΔG0), enthalpy (ΔH0), and entropy (ΔS0) were also determined. Pseudo-first-order, pseudo-second order, and intraparticle diffusion models were used to fit the experimental data. The pseudo-second-order equation was able to fit well and provide a realistic description of the adsorption kinetics.

“Study of Removal of Cationic Dyes Using Palm shell powder as Adsorbent” 2008

Authors: G. Sreelatha and P. Padmaja

Volume2
Issue2
Pages63-71
Abstract

Abstract Batch sorption experiments were carried out for the removal of Methylene Blue and Rhodamine 6G from aqueous solution using Palm Shell Powder (PSP) as adsorbent. The operating variables studied were adsorbent mass, solution pH, contact time and initial dye concentration. Adsorption experiments indicated that the adsorption capacity was dependent on operating variables and the process was pH-independent above pH 4.0. Kinetic measurements showed that the process was uniform and rapid. Sorption of dye reached equilibrium in 120 min. In order to investigate the mechanism of sorption, adsorption data were modeled using the pseudo-first-order and pseudo-second-order kinetic equations. It was found that the adsorption kinetics followed a pseudo-second-order model for the dye concentration range studied in the present work, suggesting that the rate-limiting step may be chemisorption. Equilibrium isotherm was analyzed using the Langmuir and the Freundlich isotherms. The characteristic parameters for each model have been determined. The results of Banghams equation states that the adsorption of the dye is pore diffusion controlled process. The exhaustive capacity was 121.5 and 105.0mg/g for MB and Rh6G mg/g at 25 °C with PSP .The negative value of free energy change indicated the spontaneous nature of adsorption.

Authors: G. Sreelatha, V. Ageetha, J. Parmar and P. Padmaja

DOI: 10.1021/je1007263

Volume56
Issue1
Pages35-42
Abstract

The adsorption of reactive dyes onto acid-treated palm shell powder (APSP) and chitosan has been investigated. The parameters affecting the rate process involved in the removal of dye like contact time, temperature, pH, adsorbent dose, and dye concentration were studied. pH 4 was suitable for the adsorption of both reactive dyes onto chitosan and was independent of pH in the range pH 2 to 9 using APSP as the adsorbent. The process of dye removal followed pseudosecond-order kinetics. The adsorption equilibria isotherms were analyzed by the Langmuir and Freundlich isotherms. The adsorption capacities were found to be 13.95 mg· g-1 and 24.86 mg· g-1 for reactive red 141 and reactive blue 21 using APSP as adsorbent. The adsorption capacities were found to be 22.48 mg· g-1 and 70.08 mg· g-1 for reactive red and reactive blue, respectively, using chitosan as the adsorbent.

Authors: S. Kushawa, G. Sreelatha, and P. Padmaja

DOI: 10.1021/je1013334

Volume56
Issue5
Pages2407-2415
Abstract

ABSTRACT: We have investigated the adsorption behavior of two organophosphorus pesticides Monocrotophos and Chloropyrifos onto Acid-Treated Palm Shell Powder (APSP) prepared from palm shells (agro-waste). The effects of adsorbent dose, contact time, and concentration on adsorption were studied. The Freundlich and Langmuir isotherms were applied to the experimental equilibrium data. Monolayer adsorption capacities Qm for spectrophotometric ((52.63 and 51.098) mg 3 g1 for Chloropyrifos and Monocrotophos, respectively) and for COD measurements ((14.25 and 11.57) mg 3 g1 for Chloropyrifos and Monocrotophos, respectively), have been evaluated. The calculated thermodynamic parameters ΔH, ΔS, and ΔG prove that Monocrotophos adsorption on APSP was feasible, spontaneous, and exothermic under the examined conditions, while Chloropyrifos did not show any appreciable change with temperature. The pseudo-first-order, pseudo-second-order, and intraparticle diffusion kinetic models were used to describe the kinetic data and evaluation of rate constants. The results of this study, with good correlation between spectrophotometric and COD measurements, imply the potential use of APSP as a low-cost adsorbent for removal of Chloropyrifos and Monocrotophos from industrial wastewater and runoff water from agricultural soils.

Authors: S. Kushawa, G. Sreelatha, and P. Padmaja

DOI: 10.1007/s10934-012-9571-4

Volume1
Issue20
Pages21-26
Abstract

A series of adsorbents were obtained from palm shell (Borassus flabellifer) powder (PSP) which is an agrowaste. PSP was carbonized using sulphuric acid (APSP). APSP was subjected to the following modification procedures: activation to different temperatures (3AAC, 6AAC, 7AAC and 9AAC); activation with steam and persulfate (SAPSP and PAPSP) at 140 C. Further the effect of modification of PSP, APSP, SAPSP and PAPSP using formaldehyde (MPSP, MAPSP, MSAPSP and MPAPSP) was also investigated. The materials were characterized using SEM, FTIR, TGA and XRD. N2 adsorption isotherms, DR equation and BJH methods were used to characterize the pore structure of the prepared carbons. The iodine value for APSP, SAPSP and PAPSP were found to be 342.5, 199.8, 299.7 mg/g respectively. They were also found to have large pores as well as chelating functional groups indicating their potential adsorption capacity. The carbon 9AAC was found to have high BET surface area of 834 m2/g and a pore volume of 0.4474 cm3/g with predominant micro-pores. Selectivity coefficients for different mixtures containing mercury, copper, zinc and cadmium have been determined for PSP, MPSP, APSP, SAPSP, PAPSP and 9AAC. Though PSP, APSP, SAPSP, PAPSP and MPSP did not have appreciable surface area, they showed encouraging results for adsorption of heavy metals indicating the potential use of palm shell as an economic precursor in the activated carbon preparation process.

No matching articles

Try another word from the title, author or DOI.

Brief Bio

No bio added yet.

Affiliations

Nothing added yet.

Education

Nothing added yet.

Honors & Awards

Nothing added yet.

Society Memberships

Nothing added yet.

Expertise

Nothing added yet.

Specialty

Nothing added yet.

Other Online Pages

Scholars in the same field

RP
Rakesh Pandit
0 publications
RN
Raveena Nagaram
0 publications
VH
Viet Hung Dinh
0 publications
YO
Yimkumna Ochi
0 publications
DL
Dhanya Leelamony
0 publications
NN
Nilam Navinbhai Pala
0 publications
SD
Shubhra Dubey
0 publications
PS
parimala subramani
0 publications
SS
Satyaprakash Suman
0 publications
KK
KARAMVIR KARAMVIR
0 publications
SS
simran sunita gupta
0 publications

Following

Nobody here yet.

Followers

Nobody here yet.

5 Publications

“Study of Removal of Cationic Dyes Using Palm shell powder as Adsorbent”

Authors: G. Sreelatha and P. Padmaja

Published in 2008

0 Contributions

Nothing added yet.

Filter